Drainage stack
The term ‘drainage stack’ or ‘drain stack’ is commonly used in the United States, and sometimes in commercial construction in the UK.
In very broad terms, it refers to a vertical pipe or stack that spans through one or more floors and into which drains from a property are connected to take waste water to a sewer. Branch drains run relatively horizontally from water closets, sinks, showers and so on to the vertical drainage stack which then connects to a relatively horizontal sewer at its lowest point. It may be referred to as a vent stack above the point that drains connect to it, as a drain stack below the point at which waste water drains into it and as a soil stack below the point at which sewage drains into it.
In the UK, particularly in domestic construction, it may be referred to as a soil vent pipe (SVP). Soil vent pipes allow the removal of waste from toilets, showers, baths, sinks and so on, while also allowing odours to be released above the building, via a stack vent, at a level that will not cause a nuisance. The pipe’s vent also allows air into the internal drainage system preventing a siphoning effect from occurring, and allowing free flow of waste water by gravity. An SVP may also be described as a soil stack pipe, drain waste vent or ventilated discharge pipe and is often seen on an outside wall of domestic buildings, but may be located internally.
For more information see: Soil vent pipe.
When installing drainage and ventilation pipework in high-rise buildings, traditional design standards dictate that a secondary ventilation stack has to be used to overcome air pressure changes. However, products such as the Polypipe Terrain P.A.P.A® and Pleura valves are a proven alternative to traditional secondary vented drainage systems. The P.A.P.A® (positive air pressure attenuation) valve is designed to react to and attenuate positive pressure transience within the drainage stack of high-rise developments providing a suitable venting solution for any multi-storey building.
For more information see: Secondary Ventilation Stacks in Tall Buildings.
[edit] Related articles on Designing Buildings Wiki
- Air admittance valve.
- Drainage.
- Fabricated drainage stacks.
- Greywater.
- Pumps and dewatering equipment.
- Rain gutter.
- Rainwater.
- Rainwater goods.
- Rainwater downpipe.
- Sanitary pipework.
- Secondary Ventilation Stacks in Tall Buildings.
- Sewer construction.
- Soil vent pipe.
- Soakaway.
- Sustainable urban drainage systems SUDS.
- Vacuum breaker.
- Wellpoint.
Featured articles and news
Gregor Harvie argues that AI is state-sanctioned theft of IP.
Preserving, waterproofing and decorating buildings.
Many resources for visitors aswell as new features for members.
Using technology to empower communities
The Community data platform; capturing the DNA of a place and fostering participation, for better design.
Heat pump and wind turbine sound calculations for PDRs
MCS publish updated sound calculation standards for permitted development installations.
Homes England creates largest housing-led site in the North
Successful, 34 hectare land acquisition with the residential allocation now completed.
Scottish apprenticeship training proposals
General support although better accountability and transparency is sought.
The history of building regulations
A story of belated action in response to crisis.
Moisture, fire safety and emerging trends in living walls
How wet is your wall?
Current policy explained and newly published consultation by the UK and Welsh Governments.
British architecture 1919–39. Book review.
Conservation of listed prefabs in Moseley.
Energy industry calls for urgent reform.
Heritage staff wellbeing at work survey.
A five minute introduction.
50th Golden anniversary ECA Edmundson apprentice award
Showcasing the very best electrotechnical and engineering services for half a century.
Welsh government consults on HRBs and reg changes
Seeking feedback on a new regulatory regime and a broad range of issues.